Dr Etim Nyong Bassey
B.Sc. (Chem Eng), MSc  (Chem/Petrochem Eng)  PhD (Chem Eng),
Reg. Engr (COREN), FNSE, FNSChE, MNIM (Chartered).
 
Areas of Specialisation /Research Interest: Process Integration/ Simulation/Process, Optimisation/Chemical Engineering Analysis/ Environmental Process Engineering/ Materials Engineering.

CHEMICAL ENGINEERING PROGRAMME WITH ADMISSION REQUIREMENTS
 (a) Bachelor’s Degree, B.Sc. in Chemical Engineering
Admission Requirements:
Admission into programme is done through the joint Admission and Matriculation Board (JAMB), by Direct Entry and Mature Student Programme.
University/Departmental Requirements:
West African School Certificate (WAEC), General Certificate of Education (GCE) at ordinary level, Senior Secondary School Certificate Examination (SSCE), National Examination Council (NECO) or its equivalent with at least credits in FIVE (5) SUBJECTS, IN NOT MORE THAN TWO SITTINGS, which must include English Language, Mathematics, Physics and Chemistry.
Admission Through Universities Matriculation Examination (UME):
Candidates seeking through the Universities Matriculation Examination (UME) should satisfy both the University and Departmental requirements, and perform satisfactorily in the Universities Matriculation Examination conducted by  the Joint Admission and Matriculation Board (JAMB).
Admission By Direct Entry:
Candidate seeking admission into the University by direct Entry should posses, in addition to Ordinary Level Requirements, one of the following:

1. General Certificate of Education (GCE) at Advanced Level in Mathematics and Physics or Chemistry;
2. Ordinary National Diploma (OND) at Upper Credits Level in relevant Engineering/Technology discipline from recognize Institutions;
3. Higher National Diploma (HND) at Upper or lower credit level in relevant Engineering/Technology discipline from recognized Institutions; or
4. Bachelor’s Degree in Engineering or Technology from recognized Institutions.

Admission through the Mature Student Programme.
This mode of admission is usually allowed for mature persons who show evidence of motivation and ability to benefit from the programme of the University. Such persons should not be less that 35 years of age and should have a maximum of 15 years of continuous service in an area relevant to the proposed course of study.
(b) Postgraduate Diploma, PGD. in Chemical Engineering,
Admission Requirements on a full-time basis

1. Candidates with Bachelor’s Degrees not below Second Class Lower Division in Engineering other than Chemical Engineering or relevant Sciences from recognised institutions.
2. Notwithstanding 1 above, candidates must possess the basic requirements for admission into the Bachelor’s degree in Engineering Programmes of the University of Uyo.

(c)Master of Engineering Degree, M. Eng. Chemical Engineering in:
*   Advanced Chemical Engineering
*   Environmental Process Engineering
*   Chemical Process Design
*   Petroleum Processing Engineering
*    Biochemical Engineering

Admission Requirements

Types of Admission

There are two types of admission, full time (FT) and part time (PT).
      Full Time Admission:
Full time admission is offered only to candidates who can satisfy the 
University that they are not in employment, or that they have received 
approval of their employers to undertake full time studies.  Candidates who
are found to have violated this condition shall be asked to withdraw from the
University.

 

Part Time Admission

Candidates shall be admitted to part time studies if they are members of staff of the University or in other employment where they require a higher degree to enhance their performance and knowledge.  All part time candidates shall be required to submit evidence that they will devote a good proportion of their normal working year to their studies.

Eligibility for Admission

The M. Eng. Programme shall be open to candidates with the following  qualifications:

The Bachelor of Engineering in Chemical Engineering (or closely related field of
engineering) of the University of Uyo or other recognised Institutions of  Higher Learning with a minimum of Second Class Lower Division with a  GPA of 2.75 on a scale of 5.00.  For those prospective students with  degrees in engineering fields other than Chemical Engineering, a special  course programme (usually a post-graduate diploma) will be tailored for hem to provide an appropriate background.
(1) Bachelor’s degree from a recognised Institution plus a Postgraduate Diploma in Chemical Engineering of the University of Uyo or other recognised Institutions of Higher Learning.

(2) Notwithstanding 1 and 2 above, candidates must posses the basic requirements for admission into the Bachelor’s degree in Engineering Programmes of the University of Uyo.

(d) Doctorate Degree, Ph.D. Chemical Engineering, in the areas of potential strength and interest of the Department which include the following:

1. Reaction Engineering and Catalysis
2. Process Synthesis and Simulation
3. Separation Processes
4. Environmental Emissions Reduction
5. Petroleum Processing Engineering
6. Process Optimization
7. Biochemical Engineering  etc.

Admission Requirements
Types of Admission:
There are two types of admission, full time (FT) and part time (PT).
Full-Time Admission
Full-time admission is offered only to candidates who can satisfy the University that they are not in employment, or that they have received approval of their employers to undertake full-time studies.  Candidates who are found to have violated this condition shall be asked to withdraw from the University
Part-Time Admission
Candidates shall be admitted to part-time studies if they are members of staff of the University or in other employment where they require a higher degree to enhance their performance and knowledge.  All part-time candidates shall be required to submit evidence that they will devote a good proportion of their normal working year to their studies.
 Eligibility for Admission

1.  The Ph.D. Programme shall be open to candidates with the Master of Science      (M.Sc.) or Master of Engineering (M.Eng.) degree in Chemical Engineering or its equivalent from the University of Uyo or from any other recognised institutions with a average score of not less than 60%.
2.  Candidates shall also have to fulfill the general requirements for admission as stipulated in the University of Uyo Postgraduate School Brochure.
3.  Notwithstanding 1 and 2 above, candidates must possess the basic requirements for admission into the Bachelor’s degree in Engineering Programmes of the University of Uyo.

 STAFF
Chemical Engineering Programme (Teaching)

S/N	Surname	Other Names	Sex	Qualifications with Institutions and Dates	Area of Specialization	Rank & Designation
1.	Bassey	Etim.N..	Male	Ph.D.(Bradford),1986 M.Sc.(Lvov)1974 B.Sc. (Lvov),1972   FNSE,FNSChE,COREN Reg. MNIM (Chartered)	Process Integration/ Simulation/Process Optimisation/Chemical Engineering Analysis/ Environmental Process Engineering	Senior Lecturer (Contract) & Acting Head
2.	Etuk	Benjamin.R.	Male	PhD  (Heriot Watt),1988              MSc  (Lagos),1983 B.Sc ,  1981 MNSChE, MNSE, COREN Reg.	Separation Process/ Particulate System	Associate Professor Full-Time
3	Igbokwe	Philomena K	Female	PhD (Owerri),2005 MSc (Sofia),1984 MNSChE, MNSE	Separation Processes /Process Optimisation /Environmental Pollution Control	Professor Adjunct
4	Oboho	Esio O.	Male	PhD (Moscow), 1979 M.Sc., 1973 MNSChE, MNSE, COREN Reg.	Separation Processes /Process Control	Professor Adjunct
5.	. Akpabio	Emmanuel.J.	Male	Ph.D (Moscow),1992 M.Sc.(Baku), 1989 MAIChE, MNSChE, MNSE	Petroleum Refining Engineering/Resid Catalysis	Senior Lecturer Full-Time
6.	.Ekpenyong	Ini  A.	Male	D.Sc. (MIT), 1982 B.Sc (Cal Tech.),1976	Process Synthesis /Simulation/Chemical Reaction Engineering	Senior Lecturer (Contract)
7	.Ajinomoh	Collins S		Ph.D. (Moscow), 2005 M.Sc.,1995	Petrochemical Synthesis /Environmental Engineering	Lecturer II  Full Time
8.	Igbagara	Princewell.W.	Male	Ph.D. (RUST) 1998 M.Tech., B.Sc.,1992	Petrochemical Synthesis/Chemical Reaction Engineering	Lecturer II Full Time
9.	Etuk	Victor .E.	Male	M. Eng  (Benin), 1999 P.GD , 1994 B.Sc.(Calabar), 1989	Environmental Engineering	Lecturer II Full-Time
10.	. Egemba	.Kingsley C.	Male	M.Eng . (Benin),1995  P.GD , 1994 B.Sc.(Lagos), 1990 MNSChE	Environmental Engineering& Biotechnology	Lecturer II Full-Time
11.	Babatunde	Akeem.A.	Male	MSc (Lagos), 2002 B.Eng.(Minna),1997	Environmental Engineering Separation Process & Pollution Control	Lecturer II Full-Time
12.	Alabi	Sunday.B.	Male	M.Sc. (Ife),2005 B.Sc, 1998	Control System Design and Computer-Aided Design	Lecturer II Full-Time /Staff Development
13.	Inyang	Uwem E.	Male	MTech (Port Harcourt).2000 B. Eng. (Owerri), 1994 MNSChE, MNSE, COREN Reg.	Chemical Reaction Engineering	Lecturer II Full-Time
14.	Oboh	Innocent	Male	Ph.D.((Benin) 2011 M.Eng 1998 P.GD, 1997 B.Sc., 1992 MNSChE	Biochemical Engineering	Lecturer II Full-Time
13	Bassey	Pepertua G.	Female	M.Tech (Port-Harcourt),2004 PGD, 1997 BSc. (Cal),1994	Natural Gas Engineering /Design	Lecturer ii Full-Time
14.	Ntuk	Ubong U.	Male	MSc. (Salford),2010 B. Eng. (PortHarcourt), 2006	Chemical Synthesis/Simulation Material Engineering.	Lecturer II  Full-Time

 

Technical Staff

S/No.	Surname	Other Names	Sex	Qualifications with Institutions and Dates	Rank & Designation
1.	Obot	Justine  U	Male	B. Eng. (Pet.Eng.),  MNSE, 1986	Chief Technologist
2.	Asangausung	Peter E.	Male	B. Eng. (Chem. Eng.), 1992 COREN Reg. Member NATE	Senior Technologist
3.	Udo	Udeme E.	Female	GCE., 2000 SSC E, 1995	Laboratory Assistant